GO1156

PARKING SENSOR TOOL SET - DIAM. 19MM

- Allows the professional retrofitting of parking sensors or the installation in the new bumper, which must be replaced, for example, after damage caused by an accident. It is required if there is no factory locating bore.
- Supplied with centering mandrels which are needed to place the sensor holder exactly in the middle of the hole and then glued together.
- Quality hole punches ensure exact work results and produce clean and burr-free edges. This ensures the original look will be preserved after the repair.

Technical data
Size: 19 mm
Applications
FCA
Components
1 x hole punching/centering mandrel set 2 pcs. Ø19.0mm
1 x 3/8" hole punching drive with ball bearing
1 x drill Ø10mm
GO1156